ssWe have an Intel Modular Server, Model MFSYS25V2 and I will be replacing the SCM for this unit on Tuesday Morning and have a couple of questions:
1) Once our virtual Network servers are shut down, I was told that I need to go into the Modular Server Control web page and shut down the Servers under system. If our Virtual Network servers are shut down, how will I be able to get to the Modular Server Control web page? will I still be able to access it through the ip address of 10.10.1.10?
2) Once the swap is made and I power up the Modular Server how do I get to the Modular Server Control Web page to start the servers again? The answer to question one most likely answer this question but I do want to ask just in case it is different.
I was assuming that once the Intel Modular Server was powered up the servers would power up as well however when I was talking to the tech support person the other day he told me the steps to take to swap out the SCM. I was not thinking about once the virtual servers were powered off how do I get into the Modular Server Control web page to ask him this question and today is Sunday they are not there to answer the question and I would like to swap out the SCM tomorrow morning.
a little information that might help out on answering the questions:
we have 2 domain controllers. DNS set up on them.
SonicWall router DHCP and gateway set up on this unit.
Any help would be greatly appreciated.
As Always, thanks,
Robin